|
Easy to program – just a few parameters. Airleader works out the rest itself. All the compressors and compressed air components (also from different manufacturers) are simply connected via a 2-wire cable.
A universal connection module in each compressed air component connect a wide range of different makes and models via pre-configured analog and digital ports. |
|
 |
|
| … etc. can be connected to the digital inputs of the connection modules. It is possible to select whether a digital input is used as a fault or operating signal. This allows quick overview of the status within the compressed air station. All these modes are stored for a long time and can be displayed via a browser. |
|
 |
|
| …such as flow, pressure dew point, temperature, ampere, and pressure sensors can be connected for the purpose of monitoring the compressed air system. This can provide compressed air information and volumes of different departments without great effort. A digital output, which is assigned to each analog input (e.g. temperature within the compressor room, humidity of the compressed air, differential pressure at filters) can trigger an alarm if a threshold is exceeded. |
|
 |
|
| By using the real-time timer additional 3 pressure profiles and 3 priorities can be integrated. If a compressor with heat recovery is connected, it is possible – differently from the automatic optimization – for the compressors to work on a different level depending on the consumption. Digital inputs allow the individual pressure profiles and priorities also to be selected directly. As such, rapid pressure reductions and increases are possible at the same time. |
|
 |
