01
Coordination of wiring diagrams
We provide the project-specific schematics and clarify connections, signals and interfaces with your electrical or service team.
+49 7044 911 100Services · Commissioning
Well prepared. Cleanly installed. Safely in operation.
A smooth commissioning starts before the on-site appointment. We provide you with concrete assistance with electrics and compressor settings, then integrate modules and sensors and adjust the entire station to a safe, efficient compressed air supply.
In advancePlanning for installation
On siteModules and sensors
VerifiedSafe operation
Preparation
So that the installation runs quickly and smoothly.
02
Preparing cable paths
You get clear information about which cables have to be pulled in advance between Airleader, compressors, I/O modules, sensors and network.
03
Preparing compressors
We explain which operating modes, releases, load signals and interfaces must be programmed on the compressor controls.
Installation on site
Integrate hardware and test each compressor individually.
01
Install I/O modules
We assemble and wire the required I/O modules in the compressors and integrate the relevant control signals.
02
Installing sensors
Pressure sensors and other project-specific measurement technology are professionally installed, connected and tested for plausible values.
03
Test switching function
For each compressor, we check whether release, start, load and idle are switched correctly and the feedback is reliably detected.
04
Making connections
We test whether all compressors, modules and sensors are stably connected to the Airleader and fully communicate.
Parametrisation and decrease
Combine reliable supply with efficient operation.
01
Enter station data
Flow capacities, power ranges, minimum run times, lockout times and availability are entered correctly for every machine.
02
Programming Airleader
We configure pressure band, compressor combinations, priorities and operating profiles for demand-based regulation.
03
Secure supply
Reserve behavior, malfunctions and real load changes are checked so that the required pressure is reliably present even under changing conditions.
04
Fine-tuning efficiency
In test operation, we optimize the interaction of the compressors, secure the configuration and document the transfer.
Planning for commissioning
Your installation should run smoothly from day one.
We clarify station, responsibilities and requirements at an early stage – so that everything is prepared on site.